10 If using the nut plates, starting in one corner of the template, place a nut plate over the hole drilled in
the previous step.
The other hole on the nut plate should line up with the inner 4 mm (
5
/
32
in.) hole on the template.
11 If the 4 mm (
5
/
32
in.) hole on the nut plate does not line up with the inner hole on the template, mark the new
location.
12 Repeat steps 10 and 11 for each nut plate.
13 Using a 4 mm (
5
/
32
in.) drill bit, drill the inner holes.
14 Remove the template from the mounting surface.
15 Starting in one corner of the mounting location, place a nut plate on the back of the mounting surface,
lining up the inner and outer holes.
The raised portion of the nut plate should fit into the inner hole.
16 Secure the nut plate to the mounting surface by fastening an included M3 pan-head screw through the
inner 4 mm (
5
/
32
in.) hole.
17 Repeat steps 15 and 16 for each of the nut plates along the top and bottom of the device.
18 Install the gasket pieces on the back of the device.
The pieces of the rubber gasket have adhesive on the back. Make sure you remove the protective liner before
installing them on the device.
19 If you will not have access to the back of the device after you mount it, connect all necessary cables to the
device before placing it into the cutout.
20 Place the device into the cutout.
3