Garmin G1000 Series, Руководство пилота

Страница: 51 / 338

Garmin G1000 Pilot’s Guide for the Diamond DA40
190-00592-00 Rev. A 2-23
PRIMARY FLIGHT DISPLAY
NAVIGATION STATUS BAR
The Navigation Status bar is located at the top of the
PFD and displays valuable information while flying a
route:
• The next waypoint in the active flight plan
• Distance to the next waypoint (DIS)
• Desired track to the next waypoint (DTK)
• Current track angle (TRK)
• GPS Navigation Annunciations
NOTE: The fields in the PFD Navigation Status
bar cannot be changed.
Figure 2-37 Navigation Status Bar Information Examples
Next Waypoint
Distance to
Next Waypoint
Desired Track
To
Next Waypoint
Current Track
Figure 2-38 Navigation Status Bar Messages
TRANSPONDER (XPDR) STATUS BAR
NOTE: Refer to the Transponder section for infor-
mation regarding transponder operation.
The Transponder (XPDR) Status Bar is located in the
lower right corner and displays the transponder code, re-
ply symbol, and mode of operation.
Figure 2-39 Transponder Status Bar
Transponder code selection is performed with eight
softkeys (
0
-
7
) providing 4,096 active identification codes.
Pressing one of these softkeys begins the code selection
sequence. The new code is activated five seconds after the
fourth digit is entered. The
BKSP softkey removes one
digit at a time until the status bar is empty. The VFR soft-
key can be used to enter the pre-programmed VFR code
(1200 in the USA only) selected in G1000 configuration
mode.
NOTE: Refer to ICAO standards for VFR codes in
other countries.
Pressing the IDENT softkey activates the Special Posi-
tion Identification (SPI) pulse for 18 seconds, identifying
the transponder return on the ATC screen.