Selecting a Zone
On compatible stereos, you can use the ARX70 remote control to select a zone and change the volume of the
zone. Some stereos require a software update to enable this functionality of the remote.
NOTE: When you connect to a stereo, all zones are selected by default.
1 Press
and
to enter zone selection mode.
The status LED begins flashing green.
2 Press a button to make a selection:
• Press
for zone 1.
• Press
for zone 2.
• Press
for zone 3.
• Press
for zone 4.
• Press
for all zones.
• Press
to cancel the zone selection.
When a zone is selected successfully, the status LED turns on green briefly and then turns off. When zone
selection fails, times out, or is canceled, the status LED turns on red briefly and then turns off.
NOTE: When you select an inactive or invalid zone, the remote still functions but does not control the volume.
You can select
to select all zones.
Replacing the Battery
The remote uses one CR2032 lithium coin-cell battery.
1 Rotate the remote control, and remove it from the mount.
2 Rotate the battery compartment counter-clockwise until the line points to .
3 Wrap the end of a small flat screwdriver with tape.
The tape protects the battery, battery compartment, and contacts from damage.
Selecting a Zone
3
Содержание FUSION MS-ARX70
Страница 1: ...MS ARX70 Instructions...
Страница 4: ......
Страница 10: ...support garmin com TA 2019 5078 GUID 8CCF0608 C811 4BBA B2A2 22D994B0774D v6 April 2023...