Installing the Replacement Transducer
After you remove the existing transducer, perform these actions to install the replacement transducer.
1 Install the new transducer in the nose cone (
Installing the Transducer, page 9
).
2 Install the nose cone and skeg on the propeller drive motor (
Installing the Nose Cone and Skeg, page 10
).
3 Feed the cables through the shaft (
Feeding the Cables Through the Shaft, page 10
).
4 Install the propeller drive motor on the shaft (
Installing the Propeller Drive Motor, page 12
).
Replacing the Motor Gaskets
Before you can replace the motor gaskets, you must remove the propellor drive motor and pull all cables
completely through the shaft.
1 Remove and discard the blue motor gasket and black motor gasket .
2 Using the grease packet included in the kit, apply grease to the new blue and black motor gaskets included in
the kit and install them in place of the gaskets you removed.
8