Garlock SPEEDGUARD I, Инструкция оператора

Страница: 5 / 12

5
FALLS FROM TRUCK BED CAN CAUSE SERIOUS INJURY OR DEATH
This fall protection system must be installed by a person standing on the ground or floor.
SPEEDGUARD CLAMP MOUNT
INSTALLATION INSTRUCTIONS
Use the tables and diagrams on pages 3 to guide your installations. Note the location of
each stake pocket holder.
Step 1. Securely attach a clamp on each rear corner of trailer using a fully charged impact
wrench supplied with system. Clamp is securely tightened when no movement is observed
when physically trying to pull clamp off truck.
Refer to Clamp Placement Options on page 8 for acceptable clamping methods.
Securely attach each sequential clamp. The first additional clamp will be secured 6ft from the
first clamp. Each additional clamp will be secured 8 ft apart. Use a fully charged impact wrench
supplied with system. Clamp is adequately tightened when no movement is observed when
physically trying to pull clamp off truck Refer to page 3 for spacing.
Continue to Page 6 to continue installation.
The clamps can be adjusted to fit various
trailer sides and avoid obstacles below trailer
bed by pulling the spring plunger on lower
jaw of clamp and sliding jaw extension to the
desired length.
Make sure plunger fits into 1 of the 4 holes
on side of jaw extension to secure the
extension in place.