Garland Ultimate 315 E-V15, Инструкция по эксплуатации

Страница: 29 / 104

English English
29/104
(screws, nuts, covers etc) and for any damages.
Tighten, repair or replace the pieces that you have
noticed not to be in a perfect working order. Do not
use the machine if it has lose or damaged pieces.
5.3.1. VERIFICATION OF THE ELECTRICAL
CONNECTION
Check that the connection to the mains is correct and
that the electric current is adequate for the machine.
Any attachments must comply with to the needs of
this machine.
Check that the cable is behind the machine and never
in the working area.
5.3.2. VERIFICATION OF WATER CONNECTION
Open the water intake and check that there are no
leakages. If there are any leakages, replace or repair
the hoses or its connectors.
5.3.3. PLACEMENT OF THE MACHINE
Ensure the machine is in a vertical and stable position.
5.4. START UP AND STOPPAGE
The gun has a closing security device that if in place
will not allow the gun to function.
Before starting the machine, the machine
must have its internal circuit full of water. To
fill, push the trigger of the gun with the
machine stopped (switch in the ¨o¨ position)
until water with no pressure drips from the
lance. If the pump works with the internal circuit not
full of water (working in dry conditions), the pump will
be damaged.
Start up:
Place the switch in position ¨1¨.
Remove the blocking security device of the gun and
action the trigger.
Stoppage:
Place the switch in the ¨O¨
position. The engine of the
machine will stop.
The TSS system
allows the engine
to stop when the trigger is not pressed. For a proper
usage, once the trigger is not pressed, we should wait
4 or 5 seconds before pressing the trigger again.
If the machine has not been used for a couple of
minutes you must place the On/Off switch to the Off
position ¨O¨.
NOTE: When pressing the trigger, the power of the
water forwards will have a back pull on the user.
Always hold the lance with two hands and
tightly and always be in a stable position
to avoid falling over or watering unwanted
areas.
5.5. VERIFICATION AFTER USE
Check that when the trigger is not pressed, water
does not flow out under pressure through the lance,
hose or any connectors.
If you detect any of these leakages please tighten or
repair these parts.
Security device of
the gun
On/Off switch
o
1