![background image](http://html1.mh-extra.com/html/garland/bolt-325-q/bolt-325-q_instruction-manual_3633546036.webp)
English
36/120
English
37/120
Separate yourself at least 3 meters from the refueling
area before starting the machine.
Add fuel before starting the machine. Never remove
the cap of the fuel tank while the engine is running or
when the machine is hot.
Do not use fuels such as ethanol or methanol. These
fuels will damage the engine of the machine.
6.4. MOTOR OIL
The engine of your machine comes from factory
without oil for transportation reasons. Before starting
the engine for the first time you must put oil in the
engine. This engine used quality oil for engines of
4-stroke, 20w-40 viscosity. The crankcase of engine
capacity is 0,6l.
Filling the oil tank:
• Place the machine on a clear, flat, horizontal
surface.
• Unscrew the cap of the oil tank.
• Insert 0,6l of oil.
• Wait 1 minute for the oil to lower completely to the
motor case.
• Clean the oil from the cap dipstick with a cloth.
• Insert the rod and screw the oil cap
• Unscrew the cap again and check the mark left by
the oil on the dipstick. The sign left by the oil bust
be between the minimum and maximum marks.
• If the mark is below the minimum add a little more
oil and recheck.
• If the mark is above the maximum you will have to
remove oil from the tank. To do this, tilt the mower
on its side, so that the air filter is facing up and
let out a little oil (put a bowl at the end of the tube
to prevent oil spilling from the machine or the
ground).
NOTE: This machine has an oil sensor to prevent
the engine from starting with an oil level below the
recommended minimum. If the oil level is too low the
engine will not start.
6.5. START-UP
6.5.1. VERIFICATION POINTS BEFORE
COMMISSIONING START-UP
Do not use machine is if it is damaged or incorrectly
regulated.
Use this machine for the purpose for which it was
designed. Any other use may be dangerous for the
user, for the machine and for persons, animals and
things in its surroundings.
Verify:
• The machine completely and look for parts (bolts,
nuts, etc.) that are loose or damaged.
• That there are no fuel leaks.
• The oil level.
• That the air filter is clean. Clean the filter if
necessary.
Tighten, repair or replace everything you need to
before using the machine. Do not use any accessory
on this machine outside of those recommended by us
since its use could cause serious damage to the user,
the machine and people, animals and things close to
the machine.
6.5.2. PLACEMENT OF THE MACHINE
Make sure that you install the machine in a stable
position.
Connect a cable from the ground
outlet of
generator grounding.
Содержание BOLT 325 Q
Страница 25: ...Espa ol 25 120 NOTAS...
Страница 71: ...Fran ais 71 120 NOTES...
Страница 95: ...Italiano 95 120 NOTE...
Страница 120: ......