![background image](http://html1.mh-extra.com/html/garland/air-pac-ap1/air-pac-ap1_installation-and-operation-manual_564458008.webp)
Part # 1382636 Rev 5 (01/25/08)
Page 8
OPERATION
NOTE: Disconnect line cord from power supply before
cleaning or servicing .
Break-In Period
When oven is new, operate it for one hour at 50 degrees
before you begin your normal cooking operation . After
cooling, wipe the interior, including the racks, with a clean
damp cloth .
Start Up Procedure
After the appliance has been properly installed and a start up
performance check has been performed you are now ready
to start up the oven .
1 . Inspect the oven interior for packing material .
2 . Activate power switch (A) to “ON” position .
To Adjust Oven Temperature Set Point - Press “Up” arrow .
The top display will show “SP”, followed by current set point
temperature (blinks) . Press “Up” or “Down” arrows to adjust
desired oven temperature . The display will return to actual
oven temperature after 2 seconds .
Timer Setting and Preset Adjustment
– The timer display
will be blank when Timer is Off . Press “Down” arrow once . “t1”
will display followed by flashing time setting (minutes) . Press
“Up” or “Down” arrow to adjust to desired time . This time will
be saved as “t1”, which will be the preset . The display will go
blank after 5 seconds .
To Start Timer
– Press the Timer Control button once to start
timer countdown . The timer will automatically start at the
Preset time . Press the Timer Control to turn timer off .
Temporary Timer Adjustment
– If the timer setting is
altered while the timer is running, this setting will only apply
to the current cycle until the timer has run down . Preset “t1”
will not be affected .
Independent Top Burner Adjustment
– Adjustment of
the top oven elements can be made by adjusting the dial
adjacent to the Oven Temperature Control . Example: If you
want to increase bottom browning you would reduce top
heat by turning dial to low (1), (1 – low, 6 – high) . This will
not affect internal oven temperature .
At the end of the timed cycle, an audible buzzer will sound
for 3 seconds . NOTE: The timer only serves as a signal
function and does not control heating elements or oven
temperature in any way .
LED Indicators:
K1 - Yellow; indicates heating elements are on
K2 - Green; illuminated when timer is running
K3 - Red; illuminated when audible buzzer is on
Error Message Display:
If there is a fault with the oven temperature sensor, the
Temperature Display on the controller will indicate “199”
(flashing), and the audible buzzer may sound continuously .
Heating elements will be automatically disabled (by factory
default setting) . Turn the appliance off and contact a service
person for further assistance .
Содержание Air Pac AP1
Страница 12: ......