Hoopmaster LT Portable Backstop
SETUP
4)
To set the unit the pads must be locked in place. Stepping on them can do this.
The pads are found at all four corners. Leveling can be done with the adjustment
screw.
ADJUSTMENT SCREW SETTING PADS
5)
Using masking tape and pencil, Mark the location of the center of the court 4’-0”
from the court baseline (refer to figure 5). From this center mark, establish a mark
3’-0” to the left and another mark 3’-0” to the right. These marks will be used to
align the face of bank to the court.
Figure 5
6)
Push the unit to the playing location on the court. Raise the boom to the 10’-0”
playing position. Insert the safety pin into the sliding latch bar at the rear of the
unit. Check the goal height at the base of the goal.
- 7 -
