Gardner Denver Welch VCpro 600 Series, Руководство по эксплуатации

Страница: 27 / 53

Operation
Operation manual VCpro 600 27
6
Operation
6.1 Start-up
ATTENTION
►
Read the safety instructions before start-up see Chapter 2 Safety.
1. Connect the device according to the specification and the figures; see Chapter 3.3 Pneu-
matic connections and 4.4 Device models .
2. Use the device main switch I/O to switch on the vacuum controller. After a brief initializa-
tion routine, during which STARTING is show, the vacuum controller is ready for opera-
tion.
6.2 Operating modes and system settings
6.2.1 Operating mode 1 Manual
In the operating mode Manual, the setpoint of the pressure is readjusted by the system.
PARAMETER VALUE UNIT
Set Pressure 1000 mbar
Auto Stop Time 00:00:00 hh:mm:ss
Vent at Finish Yes / No
Parameter Values from/to Resolution Default Unit
Set Pressure
0…1100
1 1000 mbar
Auto Stop Time
00:00:00…23:59:59
01:01:01 00:00:00 hh:mm:ss
Vent at Finish Yes / No No
The pressure setpoint can be specified as a parameter or adjusted in real time during opera-
tion using the operating elements,
see Chapter 4.3.1 Operating elements and display . Both
the regulated pressure drop as well as the pressure increase are possible. The pressure in-
crease requires, depending on the application, a ventilation of the system. The latter must be
released in the vacuum controller's system settings,
see Chapter 6.2.6 System settings .