![background image](http://html1.mh-extra.com/html/gardner-denver/rsd-series/rsd-series_instruction-manual_3780806003.webp)
1
RECEIVING, MOVING, AND UNPACKING
A. RECEIVING
This shipment has been thoroughly checked, packed and
inspected before leaving our plant. It was received in good
condition by the carrier and was so acknowledged.
Check for Visible Loss or Damage. If this shipment shows
evidence of loss or damage at time of delivery to you, insist
that a notation of this loss or damage be made on the delivery
receipt by the carrier’s agent.
B. UNPACKING
Check for Concealed Loss or Damage. When a shipment
has been delivered to you in apparent good order, but
concealed damage is found upon unpacking, notify the carrier
immediately and insist on his agent inspecting the shipment.
Concealed damage claims are not our responsibility as our
terms are F.O.B. point of shipment.
C. MOVING
In moving or transporting dryer, do not tip dryer onto its side.
D. STORAGE/SHUT DOWN
Dryer should not be stored outside (either packed
or unpacked) or exposed to the weather. Damage to electrical
and control components may result.
IMPORTANT: WATER-COOLED UNITS - If unit is shut down
in below freezing temperatures, the water-cooled condenser
may freeze and cause permanent damage. Condenser must be
drained when the unit is shut down.
IMPORTANT: Do not store dryer in temperatures above 130°F
(54°C).
GENERAL SAFETY INFORMATION
1. PRESSURIZED DEVICES
This equipment is a pressure containing
device.
• Do not exceed maximum operating
pressure as shown on equipment serial
number tag.
• Make sure equipment is depressurized before working on
or disassembling it for service.
2. ELECTRICAL
This equipment requires electricity to
operate.
• Install equipment in compliance with all
applicable electrical codes.
• Standard equipment is supplied with electrical enclosures
not intended for installation in hazardous environments.
• Disconnect power supply to equipment when performing
any electrical service work.
3. BREATHING AIR
• Air treated by this equipment may
not be suitable for breathing without
further purification.
Refer to applicable standards and
specifications for the requirements
for breathing quality air.