Gardner Denver Reavell 5236, Руководство по эксплуатации и техническому обслуживанию

Страница: 42 / 134

P a g e | 14
Oil Level Gauge
4.1 BEFORE STARTING
Ensure familiarity with safety devices and type of control.
Ensure suction filter is in good condition and filter element is fitted. Make sure that any protective
blank fitted to the first stage suction is removed. Check that silencer bore (if fitted) and any suction
pipework is clean before reassembling.
Check that the inside of the crankcase is clean and filled with the correct grade of lubricant until oil
level sight glass is up to maximum level. Maintain oil level no lower than sight glass centre line.
Important:- Do not overfill.
Remove plug from outer end cover, above force
feed pump and prime with recommended lubricant.
Replace plug.
Turn over the compressor at least one revolution by
hand, to ensure freedom of movement.
4.2 START-UP PROCEDURE
Screw down fully the first stage suction unloaders.
Check radiator is topped up on radiator sets or water is flowing in correct volume in mains water
installations.
Operate starter.
Check immediately that the direction of rotation is counterclockwise looking on driving end.
Check that oil pressure is above 2 bar.
WARNING!
THE COMPRESSOR SHOULD NOT BE RUN FOR LONGER THAN 30
SECONDS WITH NO OIL PRESSURE.
Check there are no uncharacteristic noises.
Run for 30 minutes unloaded.
Stop and isolate the compressor and release all pressures. Check that outer surface of machine is
cool
Remove crankcase doors and check that bearings and running gear are not over-heating. Replace
doors, ensuring joints are correctly seated.