Gardner Denver HELIFLOW 8 Series, Руководство пользователя

Страница: 47 / 64

HF-7-604 Page 46
14. Slinger and Nut Installation - Horizontal Configuration
NOTICE
The oil slingers must be installed on the bottom shaft. Assure the slingers are installed on the drive and gear
ends. The drive end slinger is smaller in diameter than the gear end slinger.
76. Position the assembly vertically with
the drive end on the top.
77. Install spacer (19) onto the drive rotor shaft.
78. Install the oil slinger (21) on the drive
rotor shaft.
79. Install spacer (19) onto Idler rotor shaft.
80. Install a bearing locknut (23) on the drive
end of both rotor shafts. Apply
Loctite246 (45) to the locknut threads
prior to screwing it onto the shaft. Use
locknut tool (T12) and a torque wrench to
tighten the locknut to 250lbs.
81. Reposition the assembly vertically
with the gear end on the top.
82. Install spacer (19) onto the drive rotor shaft.
83. Install the oil slinger (21) on the drive
rotor shaft.
84. Install a spacer (19) onto Idler rotor shaft.
85. Repeat step 80 to install (23) bearing
locknuts on both rotor shafts.