Fitting Extensions to the Xtreme44 & 47
The Xtreme44 & 47 have the option of being used with modular clamped ex-
tension sections or the #10
-
12 triple telescopic extension pack if needed for
high level work.
Standard Extensions—For use up to 64ft—
3
extensions maximum
#10
-
12 Triple Telescopic Extension Pack—
1
pack per pole
Hi
-
Strength Extensions—For use up to 79.5ft—
6
extensions maximum
We do not recommend mixing these extension sections in use on the pole.
Warning—never use the standard extensions on the pole at extended length
above 63ft. It is possible to fit 1x Modular extension section and then add the
triple telescopic extension pack to the base of the this section.
To use just 1 modular extension or the #10
-
12 triple extension pack—these
both add
-
on in much the same way as adding another fully telescopic section
to the pole. Remove the end cap from the base of the pole.
Pull out the gooseneck from the top of the pole
and disconnect the pole hose from the John Guest
connector under the gooseneck (see photo). Then
pull the hose out of the pole.
Open the lever on the extension sec-
tion and slide it on from the base of
the pole. Fully side the section up the
pole and close the clamp lever. You
will need to slide the pole hose up
from the base of the pole and re
-
connect to the gooseneck fitting be-
fore re
-
attaching the gooseneck.
This first modular extension section can now be used just like a 10th section
on the pole. Always ensure that you allow sufficient overlap on this section
when using. The base handle section will have a painted band to indicates the
maximum safe extension point.
