GardePro A3S, Инструкция по эксплуатации, Страница: 9 / 27

6
about both batteries and SD cards you should be aware of, so
please take the time to read the following directions and
cautions :
5.1. LOADING BATTERIES
After opening the cover of the battery compartment, you will
see that the camera has eight battery slots (
Figure 6
). A full
eight batteries must be installed for the camera to operate. Be
sure to insert each battery with correct polarity (negative or
"flat" end against the long spring of each battery slot).
In the
SET mode when battery power level gets low, the
message " Low Battery " will show on the screen, please replace
the batteries. If the battery indicator shows in RED, this does
mean the batteries are not able to drive IR LEDs flash at night,
however the batteries still work at daytime until "Low Battery".
If you want to continue night vision, please replace the
batteries.
Figure 6: Loading the Batteries
5.2. INSERTING THE SD CARD
Insert the SD card (with the camera's power switch in the
OFF
position) before beginning to operate the camera. Don't insert or
一