POWXG9513
EN
Copyright © 2018 VARO NV
P a g e
|
6
www.varo.com
12 TROUBLESHOOTING
Incidents
Causes
Remedies
Pump does not start
-
No mains supply
-
Floater does not
switch
-
Check mains supply
-
Bring floater in a higher
position
No flow
-
Inlet sieve is clogged
-
Pressure hose in
bent
-
Clean inlet sieve water
jet
-
Reset hose
Pump does not switch off - Floater cannot sink down
- Place pump properly on shaft
ground
Insufficient flow
-
Inlet sieve is clogged
-
Reduced pumping
capacity by dirty and abrasive
water
-
Clean inlet sieve
-
Clean pump and replace
worn-out parts
Pump switches off after
short operating period
-
Thermal cutout stops
pumps due to dirty water
-
Water too hot.
Thermal-cutout stops pump
-
Remove mains plug.
Clean pump and shaft
-
Make sure that a water
temperature of max. 35°C is not
exceed
13 STORAGE
▪
Thoroughly clean the whole machine and its accessories.
▪
Store it out of the reach of children, in a stable and secure position, in a cool and dry
place, avoid too high and too low temperatures.
▪
Protect it from exposure to direct sunlight. Keep it in the dark, if possible.
▪
Don’t keep it in plastic bags to avoid humidity build-up.