POWXG4060
EN
Copyright © 2013 VARO
P a g e
|
7
www.varo.com
Reinstall the air filter into the filter base.
Push the cover back in place. Push the latch back into the slot and ensure the cover is
locked in place.
9.2
Clean Fuel Filter
Fuel tank is fitted with a filter.
Filter is situated at the free end of fuel pipe and can be picked out through fuel port with a
piece of hooked wire or the like. (Fig. 16)
Check the fuel filter periodically. Do not allow dust to enter the fuel tank. Clogged filter will
cause difficulty when starting engine or abnormalities in engine performance.
When the filter is dirty, replace the filter.
When the inside of the fuel tank is dirty, it can be cleaned by rinsing the tank out with
petrol.
9.3
Checking the spark plug
Check the spark plug every 10-15 hours of use.
Remove the spark plug cover. (Fig. 17)
Use the spark plug wrench to remove the spark plug, by turning it counter-clockwise. (Fig.
18)
Clean and adjust the spark plug gap to 0.6 - 0.7mm.
Replace any damaged or visibly worn plug with a TORCH L8RTC or equivalent spark plug.
(Fig. 19)
Install the spark plug finger tight in the cylinder head, and then tighten it firmly with the
spark plug wrench.
10 TECHNICAL DETAILS
Model nr.
POWXG4060
Engine displacement
25 cm³
Fuel tank
500 ml
Fuel type
Unlead
Fuel mixture
40:1
Max. engine speed
8500 rpm
Air velocity
180m/s
Air volume
9m³/min
11 NOISE
Noise values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
96 dB(A)
Acoustic power level LwA
107 dB(A)
ATTENTION! The sound power level may exceed 85 dB(A), in this case
individual hearing protection shall be worn.
aw (Vibration)
11.6 m/s²
K = 1,5 m/s²
12 PROBLEMS
12.1
Power loss or sudden stopping of the engine
Check whether the fuel tank is empty.
The mixture does not reach the carburetor. Clean the fuel filter in the fuel tank.
There is water in the mixture. Drain and rinse all the fuel system.
