POWXG2040
EN
Copyright © 2012 VARO
P a g e
| 5
www.varo.com
6 ADDITIONAL SAFETY INSTRUCTIONS
Do not use the trimmer in the rain.
If the cord is cut or damaged remove it immediately from the power point.
Keep hands and fingers well away from the blade.
Wear work gloves, eye protection, solid shoes and trousers when using this hedge trimmer.
Always grasp both handles when operating the unit.
Disconnect the trimmer from the mains supply when you have finished work, before
cleaning or if you have been interrupted.
This trimmer has been designed to cut soft, new growth and should not be used on
branches, hard wood or other forms of cutting.
Do not attempt to free a jammed blade before first switching off the machine and
disconnecting it from the mains supply
If you are interrupted when operating the trimmer, complete the process and switch off
before looking up.
Never allow untrained users or children to use the trimmer.
7 OPERATION
7.1
Assemble the cutting head to the unit.
The cutting head is supplied lonely, you must assemble it correctly before you use the unit
.
Remove the plug from the power supply, and release the trigger
.
Align the cutting head to the support housing and then rotate it by clockwise until it is
locked.
Align the hole in the support housing with the screw on the cutting head
.
Tighten the screw securely by screwdriver
.
And then rotating the handle to the comfortable
position by press the locking knob.
Always ensure the front handle is fitted to the shaft whenever you operate
this tool!
7.2
Adjust the cutting length
Lift the knob (8) on the coupler
.
Pull the lower shaft till it in a comfortable position
.
Tighten the knob securely
.
If the button does not release completely in the positioning hole, the shafts
are not locked into place. Slightly rotate from side to side until the button is
locked into place.
Be certain the knob is fully tightened before operating equipmentl check it
periodically for tightness during use to avoid serious personal injury.
7.3
Adjust the cutting angle
Press the rotating knob.
Adjusting the cutting head to a comfortable position.
Release the knob.
7.4
Starting and stopping the machine
To start the tool: press the safety button (11) and then press the trigger (12). Release the
safety button once the motor has started.
