AFTER SALES SUPPORT
23
1300 855 831
AUS Hotline Costs: Local rate for landline calls*
*Charges may vary dependent upon network operator or mobile network provider.
MODEL: HL650o PRODUCT CODE: 63736 04/2019
AUS
Operation/Cleaning/Maintenance and repair
JAMMED LOG, FIG. 3 / 4
Do not try to knock the jammed log off. Knocking about will damage the machine
or may launch the log and cause accident.
1.
Release both controls.
2.
After the Log Pusher (2) moves back and completely stops at its starting posi-
tion, insert a wedge wood under the jammed log as shown in the figure.
3.
Start the log splitter to push the wedge wood under the jammed one.
4.
Repeat above procedure with sharper slope wedge woods until the log is com-
pletely freed.
IX. CLEANING
m
IMPORTANT!
Always pull out plug each time before carrying out any cleaning.
Keep all safety devices, air vents and the motor housing free of dirt and dust as
far as possible.
Wipe the equipment with a clean cloth or blow it with compressed air at low pres-
sure -
Attention! Wear safety glasses for this work.
We recommend that you clean the device immediately each time you have fin
-
ished using it.
Clean the equipment regularly with a moist cloth and some soft soap. Do not use
cleaning agents or solvents - these could attack the plastic parts of the equip-
ment. Ensure that no water can seep into the device.
X. MAINTENANCE AND REPAIR
Carry out refitting, setting and cleaning work only when the motor is switched off.
Pull the power plug.
An experienced worker can carry out minor repairs on the machine alone.
Repair and maintenance work on the electrical system may only be carried
out by a qualified electrician.
All protective and safety devices must be reattached immediately after completed
repair and maintenance work.
We recommend:
• The Splitting Wedge is a wearing part that needs to be sharpened or replaced
after wear.
• The combined gripping and controlling device must remain smooth running. Lubri-
cate with a few drops of oil when necessary.
• Keep Splitting Wedge drive clean of dirt, wood shavings, bark, etc.
• Lubricate slide rails with grease.
