After Sales Support TEL: 1300 130 579 WEB: www.rossmac.com
4
Before you put the dirty water pump into operation,
carefully read the following safety regulations and the
operating instructions.
If you give the equipment to any other persons, give
them the operating instructions as well.
Keep these instructions in a safe place.
Packaging
The unit is supplied in packaging to prevent it from
being damaged in transit. The raw materials in this
packaging can be reused or recycled.
1. Safety instructions
Caution!
In stagnant water bodies, garden ponds,
swimming ponds and their surrounding areas the
pump may only be used with an earth-leakage
circuit breaker with an actuating rated current of
up to 30 mA (acc. to VDE 0100 part 702 and 738).
The pump is not designed for use in swimming
pools and paddling pools of any kind or other
bodies of water in which people or animals may
be present during operation.
It is prohibited to operate the pump if a person or
animal is in the danger area.
Ask your electrician!
●
Before starting to run your new pump, please have
the following items checked by an expert:
- Ground connection
- Zero conductor
●
Safety circuit breaker switch must correspond
to the safety regulations of the power plants
and they must work faultlessly.
●
The electrical connections must be protected from
moisture.
●
If there is danger of flooding, the electrical
connections must be taken to higher ground.
●
Circulation of aggressive fluids, as well as the
circulation of abrasive materials must be avoided
at all costs.
●
The pump must be protected from frost.
●
The pump must be protected from running dry.
●
Access on the part of children should also be
prevented with appropriate measures.
2. Layout (Fig. 1)
1 Handle
2 Integrated cable rewind
3 Universal hose connection
4 Venting
5 Floating switch
6 Cable holder
3. Installation (Fig. 2)
The pump is installed as follows:
●
In a stationary position with fixed pipeline
or
●
In a stationary position with a flexible hose pipe.
You should never install the pump by suspending it
unsupported from its delivery pipe or power cable.
The pump must be suspended from the specially
provided handle or be placed on the bottom of the
shaft. To guarantee that the pump works properly,
the bottom of the shaft must be kept free of sludge
and dirt of all kinds.
If the water level becomes too low, any sludge in the
shaft will dry out quickly and stop the pump from
starting up. It is necessary, therefore, to check the
submersible motor pump regularly (by carrying out
start-up tests).
The float is adjusted in a way that the pump can
immediately be started
The pump shaft should have minimum dimensions of
40 x 40 x 50 cm, so that the floating switch can move
freely.
2
Anleitung GLSP 1002_SPK7:Anleitung GLSP 1002_SPK7 27.06.2008 11:25 Uhr Seite 4
