Gardenia SF7A103, Руководство пользователя

Страница: 28 / 31

28
3.3 Cleaning, maintenance, transportation and storage
Before any work on the electric mower, remove the plug..
3.3.1 Cleaning the mower
- Regular cleaning after use will ensure a better functioning and greater life of the electric mower.
- Tilt the machine on its side and clean the cutting of grass remains off with a spatula and brush. Straighten the
mower on its wheels.
-
Clean grass catcher with a brush or water jet to keep the vents clear. Let it dry naturally and put it into place later.
- Clean the surface with a soft damp cloth. Never clean plastic with a chemical that might damage them.
3.3.2 Maintenance of the mower
Cutting system
Before and after each use, check the blade, the blade bolts and cutter assembly are not worn or damaged. A
deformed or worn blade must be replaced. Never straighten a bent blade. When the blade is damaged, replace
it as soon as possible.
Use only original parts or approved by SELLER.
Excessive vibration during operation of the machine must warn you because it comes a very often problem with
the cutting system.
WARNING : Never work with a bent or damaged blade, because it generates vibrations and may cause damage to
the mower. Never work with excessively worn blade because you might
hurt yourself.
WARNING : It is better for security reasons, to entrust all the work (replacement and / or sharpening blades, repair of
the cutting system), a specialized workshop.
Sharpen the blade
For best results, make sharpen and balance the blade at least once a year by a specialist workshop.
Remove the blade
Get yourself a pair of gloves to avoid injury when handling the blade.
Disconnect the plug and tilt the mower on its side.
Loosen the screws holding the blade with a wrench while holding the blade firmly with one hand and stuck with a
plank of wood.
Install the blade
Get yourself a pair of gloves to avoid injury when handling the blade.
Disconnect the plug and tilt the mower on its side.
Ensure the cleanliness and condition of the blade support and screw blade..
Place the blade on the support, cooling fins to the motor. Check the alignment of the blade and centering pins of
the support with the blade. The blade must be perfectly positioned on the support.
Tighten the screw until it touches all parts. Make a final visual inspection of the alignment of all parts and tighten
screw firmly with a wrench while holding the blade with one hand and stuck with a plank of wood.