POLYCARBONATE GLAZING – see Page12
Installment instruction for glass is divide into small part glass page12 and main part glass page 13.
1. The table on the left side and right side includ size and quantity of theglass
2. The installment of corresponding position of the glass is shown in upper right and lower left.
3. Installment of H-strip 13 page.
4. Do not walk on polycarbonate panels.
5. Do not scratch polycarbonatepanels.
6. Do not use abrasive cleaners with polycarbonate glazingpanels.
POLYCARBONATE – see Page14.
1. Page 14 of the instructions shows how to fit the polycarbonate glazing.
2. Before fitting the polycarbonate peel back approximately 50mm of the protective film from all edges
of the polycarbonate sheets. Do not remove the protective film until after the installation is complete.
3.
4.
5
.
6.
7.
The chart on Page 14 shows the part number, the size in millimetres and the quantity of each
polycarbonate panel.
At windy locations silicone sealant can be applied to the gasket (part 1054) to provideadditional
adhesion.
Do not walk on polycarbonate panels.
Do not scratch polycarbonatepanels.
Do not use abrasive cleaners with polycarbonate glazing panels.
