Step 3.
Plug the power cord into the end of one Ballast.
Step 4.
Connect the Light Tubes together by plugging in
the Link Cord. The Link Cord is specifically molded to
fit only one way on the end of each Ballast. If is does
not fit, make sure the Ballasts are positioned with
one male and one female socket at each end of the
Light fixture.
Step 5.
Install the Light Tubes by sliding the pins on the
Light Tube into the Ballast sockets, then rotate the
Tube 90 degrees until it “locks” into place (Figures
5 and 5a). Installing the Tubes correctly will ensure
they produce the optimum amount of light. Do not
force the Tubes into place. Turn the Light Fixture
upright. Remove the protective plastic film from the black
side of the Light Fixture Hood.
Ball Chain Assembly
Step 1.
Attach a Chain Connector to both Split Rings
(Figure 6). If necessary, use pliers to pry open the Split
Rings. (Needle nose pliers work best.)
Step 2.
Connect one end of each Ball Chain to the Chain
Connectors on the Split Rings. The last ball of each chain
will “snap” onto the connector (Figure 6).
Step 3.
Take the loose end of one Ball Chain and thread it
through the Chain Grip (Figure 6a) then through the Guide
Hole in the top S2 and A3 Bar (Figure 7). Direct the loose
end of the chain over the spacer inside the A3 Bar
(Figure 7). If this proves difficult, attach a twist-tie to the
end of the chain to help lead the chain over the spacer or
tip the frame onto its side. Repeat to install the Ball Chains
on both sides.
Step 4.
Attach a Chain Connector and Small Split Ring to the
end of each Ball Chain (Figure 7).
Step 5.
Find the two slots with the “T”-shaped tabs in the top
of the Light Fixture. Hook each hanging Small Split Ring
around the “T”-shaped tabs (Figure 8).
Tip
: angle the ring
around one side of the T, then the other.
assembly continues on next page
Figure 4
Ballast
Ballast
Clip
closed pin
male socket
open pin
female
socket
closed pin
Figure 5a
Slide pins
into sockets
Light
Tube
Rotate 90 degrees
until Tube "locks"
into place.
Figure 3
-3-
Chain
Connector
Large Split Ring
Figure 6
Ball Chain
Chain Grip
Figure 6a
Figure 8
Hook the Split Rings around
the “T”- shaped tabs to hang
the fixtures.
A3
Spacer
Guide
Hole
A1 Side
Frame
Ball
Chain
Chain
Connector
Small Split
Ring
Figure 7
Small Split Ring
