5.
Again using
Fig. 2
and the ASSEMBLED PANEL as references, place the
FLAT STOCK underneath the PLATFORM SUPPORT. Align the holes 4th
from the top of the FLAT STOCK with the holes in the PLATFORM SUPPORT
and make sure they are straight.
Secure the FLAT STOCK into place by
inserting SCREWS through all of the holes.
6.
Repeat Steps 2–5 to assemble the other side panel.
7.
Use a rubber mallet to tap an ASSEMBLED 4' PANEL into the open
channel of a CORNER, positioning it so the attached CROSS SUPPORT sits
underneath the PLATFORM SUPPORT on the side panel(
Fig. 3
). Make sure
the top of the ASSEMBLED PANEL sits 1/8" above the top of the CORNER
and is fully seated inside, then insert SCREWS into the holes in the CORNER
and through the lined up holes in the ends of the CROSS SUPPORT and
PLATFORM SUPPORT. Repeat to attach the remaining ASSEMBLED 4'
PANEL.
8.
Place the remaining side panel on a flat surface. Carefully lift the other attached PANELS and guide the ends of the ASSEMBLED 4'
PANELS into the open channels of the CORNERS on the remaining side panel to form a box. Insert SCREWS through the holes in
both CORNERS. Once all PANELS are attached, tilt the Raised Bed so it is upright.
9.
Set the FLOOR PLANKS on top of the SUPPORTS, arranging them so there are small gaps between the planks.
NOTE:
The gaps
allow water to drain. Place the FABRIC LINER over the FLOOR PLANKS.
10.
Insert a CORNER CAP into the top of each aluminum CORNER, using a rubber mallet if necessary. The raised bed assembly is
complete!
This elevated raised bed holds approx. 329 quarts of planting mix. Fill it with potting mix and, if you wish, some organic matter, such
as compost. We also recommend adding a slow-release fertilizer like our Organic All-Purpose Fertilizer (sold separately).
NOTE:
Avoid
using a heavy potting soil or placing rocks and broken pottery into the Raised Bed. Now you’re ready to plant!
For how-to articles and videos on growing vegetables and flowers in containers and raised beds, visit us at
gardeners.com
Figure 3
SCREW
ASSEMBLED 4' PANEL
The attached
CROSS SUPPORT
sits underneath
the PLATFORM
SUPPORT.
PLATFORM
SUPPORT
SIDE PANEL
PLEASE
RECYCLE
