1-800-876-5520 • gardeners.com
Parts List
Frame Assembly
Cross Cable Assembly
(1) TOP PANEL
(4) ANGLE BRACKETS
(2) SIDE PANELS
(8) SCREWS
(2) RAILS
(4) LARGE BANJO SCREWS
(1) SHELF
(2) CABLES
(4) WOODEN DOWELS
(8) CROSS DOWEL
(8) BOLTS
HEX KEY included
Assembling the Frame
NOTE:
Before beginning assembly, check the predrilled holes in the wood and
clear out any debris. Do not tighten the BOLTS completely until the entire FRAME is assembled.
1.
Insert the WOODEN DOWELS into the top holes on the inside corners of both SIDE PANELS (
Fig. 1
).
NOTE:
The bottom
of the SIDE PANEL has feet.
2.
Using
Fig. 1
as a reference, line up a RAIL with a SIDE PANEL, positioning
it so the groove is closer to the top. Choose a BOLT and CROSS DOWEL to
use for the next step.
Important:
To make sure all of the pieces go together
smoothly, test to make sure the BOLT fits through the holes in the SIDE
PANEL, RAIL, and CROSS DOWEL (
Fig. 2
). With the CROSS DOWEL,
sometimes the threads on one side line up the with the BOLT threads
better than the other side, so make sure to try inserting the BOLT into both
sides of the CROSS DOWEL.
3.
Place a CROSS DOWEL fully into the opening in the RAIL face up (
Fig. 1
).
Make sure the hole in the DOWEL is lined up with the hole in the end of
the RAIL. Slide the WOODEN DOWEL in the SIDE PANEL into the top hole in the RAIL.
4.
Place a BOLT through the holes in the SIDE PANEL, RAIL, and CROSS DOWEL as shown in
Fig. 1
. Use the HEX KEY to secure it into
place.
NOTE:
If the BOLT won’t screw into the DOWEL when it is fully insert into the hole, try holding the CROSS DOWEL flush with
the surface of the RAIL (
Fig. 3
). One of these two placements should allow the BOLT to screw into the CROSS DOWEL.
5.
Repeat Steps 2-4 to attach a RAIL to the other corner on the same SIDE PANEL.
6.
Slide the TOP PANEL into the grooves on the RAILS (
Fig. 4
). Then repeat Steps 2-4 to attach the remaining SIDE PANEL to the open
ends of the RAILS.
over please
8% of our profits
go back to our communities.
Learn more at gardeners.com/
FoRCE-FoR-GoOD
Figure 1
CROSS DOWEL
groove
RAIL
SIDE PANEL (top corner)
WOODEN DOWEL
BOLT
If the BOLT won't screw in when
the CROSS DOWEL is fully
inserted in the hole, try it again
when the CROSS DOWEL is flush
with the surface of the RAIL.
CROSS DOWEL
Figure 3
SIDE PANEL
TOP PANEL
RAIL
RAIL
Figure 4
BOLT
SIDE
PANEL
RAIL
CROSS DOWEL
BOLT
BOLT
Figure 2
1354G Rev 01/20
#8599950
Stand for Low Bamboo Grow Light
