SunLite® Tabletop Garden
Assembly Instructions
T
here are four parts to assembling the
SunLite Garden: Frame Assembly, Ball
Chain Assembly, Adjusting the Fixtures, and
Installing the Light Tubes. With the help of
one other person, you can assemble the SunLite
Tabletop Garden in less than an hour. The only
tools you’ll need are a Phillips screwdriver, a
hammer or rubber mallet, and pliers.
Frame Assembly
Step 1.
Lay out all Frame Parts on a flat, clean
surface.
Step 2.
Connect an A4 Side Base Frame to the
end of each A2 Bar using two Phillips-head bolts
(Fig 2). Repeat this step to connect the second A4
Side Base Frame to the other end of the A2 Bars.
Do not fully tighten the bolts on the frame until
Step 4.
Step 3.
Connect the A1 Side Frames to the A4
Side Base Frames by placing a Phillips-head bolt
up through the hole in the underside of the A4
Frame. Make sure the nylon cleat on each A1 Side
Frame is facing out (Fig. 2).
A2 Bar
Light Fixture
A4
Side
Base
Frame
A1 Side Frame
with Cleat
Fig. 1
Enlarged
view of
cleat
A1
Side
Frame
A2
Bars
A4 Side
Base Frame
Fig. 2
Parts List
Qty.
Frame
A1 Side Frames
2
Parts:
A2 Bars 2
A3 Pulley Bars
1
A4 Side Base Frames
2
Additional
Light Fixtures
1
Parts:
T-8 Light Tubes
3
Poly Tray
1
Hardware:
Ball Chains
2
Chain Connectors
4
Split Rings,Large
2
Split Rings,Small
2
Bolts
8
End Plugs
6
Bolt
Bolts
