1. Main
switch
2. STOP
button
3. LED for function check of the
boundary and guide wires
4. Cutting height indication
5. Display
6. Keypad
1. Placement of and connecting the charging
station
See chapter 3.2 in the Operator’s Manual
1. Place the charging station at a central position in the work area, with a lot of open
space in front of the charging station and on a relatively horizontal surface.
2. Connect the transformer’s low voltage cable to the charging station and the
transformer.
3. Connect the transformer to a 230 V wall socket.
2. Charging the battery and
placement of the boundary wire
See chapter 3.3 and 3.4 in the Operator’s Manual
1. Place the robotic lawnmower in the charging station to charge
the battery while the boundary wire is laid. Set the main
switch to position 1.
2. Run the boundary wire ensuring it forms a loop around the
work area.
3. Make an eyelet at the point where the guide wire will be
connected later (see point 4.5).
Charging station
1
2
3
4
5
1
2
3
4
5
6
7
8
0
9
GARDENA
Start
4
5
6
1
2
3
1
2
3
20 cm / 8
”
10 cm / 8”
0 cm / 0”
5 cm / 2”
30 cm / 12”
GETTING STARTED WITH
THE GARDENA ROBOTIC LAWNMOWER
3. Connecting the boundary wire
See chapter 3.5 in the Operator’s Manual
1. Open the connector and lay the wire ends in the recesses on each connector.
2. Press the connectors together using a pair of pliers.
3. Cut off any surplus boundary wire. Cut 1 to 2 cm above the connectors.
4. Press the connectors onto the contact pins, marked A, on the charging station. It is
important that the right-hand wire is connected to the right-hand contact pin, and the
left-hand wire to the left-hand pin.
4. Placement of and connecting the guide
wire
See chapter 3.6 in the Operator’s Manual
1. Run the guide wire through the slot at the bottom of the charging station.
2. Fit the connector to the guide wire in the same way as for the boundary wire,
according to the instructions above.
3. Fasten the connector to the contact pin marked Guide on the charging station.
4. Lay the guide wire at least 2 metres straight out from the front edge of the
charging station.
5. Run the guide wire to the point on the boundary loop the connection will be made.
Avoid laying the wire at tight angles.
6. Cut the boundary wire with a wire cutters at the centre of the eyelet that was made
in point 2.3.
7. Connect the guide wire to the boundary wire using the accompanying couplers.
Press the couplers completely together with a pair of pliers.
Transformer
Low voltage cable
Boundary wire and
couplers
Staples
Connectors
Measurement
gauge
1
7
4
2
4
3
min 2 m / 7 ft
1
1
