4
ASSEMBLY INSTRUCTIONS
2. Attach a table leg (C) to the leg connector bracket
(B) by carefully guiding the bolts (AA) previously
assembled on table leg (C) through the holes in the
leg connector bracket (B). Add a washer (BB) and
nut (CC) to the end of each bolt (AA). Hand tighten
only. Repeat for the other three table legs (C).
3. Tighten all bolts and nuts using the hex
bolt driver (GG) and hex wrench (FF). Note: Tighten
each bolt a few revolutions at a time. It is
recommended you work working in a cross (X)
fashion, alternating between bolts and nuts. This will
tighten the frame evenly by placing equal pressure
on all bolts and nuts joints. Do not overtighten.
Cover the bolts and nuts with bolt covers (DD) and
nut covers (EE).
With the help of another person, carefully turn the table
in the upright position. Your table is now ready for use.
1. Place the tabletop (A) upside down on a flat,
non-abrasive surface. Attach the table leg (C) to the
tabletop (A) with bolts (AA) and washers (BB). Hand
tighten 2-3 revolutions only. Repeat for the other
three table legs (C).
1
Hardware Used
BB
Washer
x 4
AA
Bolt
x 4
2
Hardware Used
CC
Nut
x 8
BB
Washer
x 8
3
Hardware Used
FF
Hex Bolt Driver
x 1
GG
Hex Wrench
x 1
DD
Bolt Cover
x 4
EE
Nut Cover
x 8
Lowes.com/gardentreasures