8
9
ASSEMBLY INSTRUCTIONS
Hardware Used
Hardware Used
WARNING:
Two people are required to
safely assemble the product!
1. Assemble the three lower supports (K) to
the bottom plate (N) and control box assembly
(I) using the M5 x 12 mm screws (DD).
Align the side of bottom plate (N) with the
holes with the side of control box assembly (I)
with the knobs. Make sure the bottom plate (N)
and control box assembly (I) are not upside
down, then use Phillips screwdriver (OO) to
fasten each to the lower supports (K) with
M5 x 12 mm screws (DD). DO NOT yet tighten
the M5 x 12 mm screws (DD) on control box
assembly (I).
2. Using wrench (NN), assemble the wheel
assembly (M) to the bottom plate (N) with
M6 x 10 mm bolts (EE).
M5 x 12 mm Screw
M6 x 10 mm Bolt
x 9
x 8
DD
EE
Philips
Screwdriver
x 1
OO
1
2
I
DD
K
N
N
EE
M
Wrench
x 1
NN
A dented, rusted or damaged propane cylinder
may be hazardous and should be checked by your
cylinder supplier. Never use a propane cylinder with
a damaged valve connection.
The propane cylinder must be constructed and
marked in accordance with the specifications
for LP gas cylinders of the U.S. Department of
Transportation (DOT) or the standard for cylinders,
spheres and tubes for transportation of dangerous
goods and commission, CAN/CSA-B339.
The cylinder must have a listed overfilling
prevention device.
The cylinder must have a connection device compatible with the connection for the appliance.
The cylinder used must include a collar to protect the cylinder valve.
Never connect an unregulated propane cylinder to the heater.
Do not store a spare LP-gas cylinder under or near this appliance.
Never fill the cylinder beyond 80 percent full.
Place the dust cap on the cylinder valve outlet whenever the cylinder is not in use. Only install the
type of dust cap on the cylinder valve that is provided with the cylinder valve. Other type of caps or
plugs may result in leakage of propane.
1
Standard 20 lb. tank
SAFETY INFORMATION
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list and hardware contents list. If any part is missing or damaged, do not attempt to
assemble the product.
Estimated Assembly Time:
60 minutes
Tools Required for Assembly (not included): Phillips Screwdriver and Leak Detection Solution.
