TIPS:
Before Beginning
●
Read the instructions thoroughly.
●
For future reference, save this instruction sheet.
A. Press and hold the Electric Ignitor. Meanwhile, push and turn the Control Knob counter-clockwise to the "LOW"
position. Keep pushing the Control Knob to light the burner .
B. After ignition, release the Electric Ignitor. Continue to push and hold the Control Knob for 45 seconds.
C. If ignition does NOT immediately take place in seconds, push and turn the Control Knob clockwise to "OFF". Wait 5
minutes, then repeat the lighting procedure as above.
Caution:
*If the burner does not ignite with the valve open, gas will continue to flow out of the burner and could
accidently ignite with risk of injury.
This screen must be clear and free of
obstructions at all times to insure proper
operation.
Before each use, inspect all hose. Replace hose if there are any signs of cutting, wear or abrasion.
(1) Turn the cylinder valve on the gas tank counter-clockwise to open the gas supply.
(2) Close the storing door on the firebowl for the gas tank.
(3) Light the firebowl as below steps:
INCORRECT
CORRECT
Perform leak test in a well ventilated area outside and where no source of spark can occur.
Remove battery from igniter. Open tank valve fully (counter-clockwise). Turn the on/off valve at the unit to the ‘off’ position to
pressurize the hose assembly. Use a soapy water solution to check all the connections leaks before attempting to light the appliance.
If
a leak is found, turn the tank valve off and do not use the appliance until repairs can be made.
●
Check and make sure that all parts are present.
TO LIGHT
The burner of the firebowl must be covered
by lava rock completely. Otherwise the flame
may be extinguished occasionally. See the
Figure CORRECT and INCORRECT for
reference.
WARNING
See WARNING and Figures :
LOW
HIGH
OFF
IGNITER-PUSH
8
