2
If you choose to vary from these instructions your
warranty will be impaired.
If you need advice, call us
FREE
on
0800 807 433
or email us at [email protected]
!
i
COMPONENTS CHECKLIST
Please check the parts carefully and advise immediately if any are damaged or missing.
A
3 x 1770mm sheets for the back
B
2 x 1830mm - 1770mm sloping sheets
(side walls 1 left, 1 right)
C
3 x 980mm sheets for the roof
D
1 x780mm wide sheet with
door jamb attached
E
Door pre-hinged to 700mm sheet
with door jamb
F
4 x 780mm channels for end walls
2 x 2255mm channels for the roof
G
4 x 2255mm channels with ends cut for
front and back walls
H
2 x 980mm ‘L’s for flashing the roof
to the side walls
I
2 x 793mm door spacers
1 x pack of rivets with padbolt for Zincalume
sheds, rivets for colour sheds, 2 x ‘Z’ door
braces and riveter for general assembly
Pan
Rib
J
IMPORTANT!
•
Remove the swarf (drill filings) from the panels as you assemble them.
•
All components are cut to length. Do not cut any parts unless instructed.
•
Rivets through the inside of the channels into the sheeting are just as important
as rivets from the outside.
RIBS AND PANS
•
Generally most rivets are spaced at 300mm apart.
•
Keep the rivets in the pans as close to the ribs as possible for added strength.
•
Ribs will always protrude to the outside of the shed.
•
Extra internal rivets are strongly recommended in high wind areas.
DIAGRAM 1
DIAGRAM 2
DIAGRAM 3
BUILDING YOUR SHED
The basic task is to join the sheets together to form your
panels, and rivet channels to the top and bottom of these
panels. They will then join together to form your shed
(diagram 1, 2 and 3).