Garden Leisure Garden-696L, Руководство пользователя

Страница: 15 / 24

12
CONTROL PANEL OPERATION
ECONOMY MODE:
The spa will not heat. Water
sampling only done during the filter cycle.
SLEEP MODE:
The spa will only heat during the
filter cycles. Water sampling only done during the filter
cycle.
QUIET MODE:
Keeps the jet pump from
running (water sampling) after the F2 filter cycle
is complete for up to 11.5 hours. You can set this
mode between 0.5 hours and 11.5 hours in half
hour increments. To enter the programming screen
and toggle between Standard, Economy, Sleep and
Quiet Modes the following is required:
FAHRENHEIT/CELSIUS
SETTING:
To change water temperature display to either
Fahrenheit or Celsius, press and hold Light
button for 5+ seconds until F1 is displayed.
Press the Light button several times until F or C
is displayed. Press the Plus or Minus button to
change. Wait 15 seconds to allow the exit timer to
expire and store the setting.
OPERATIONAL MODES
(Garden-
696L, Garden-680L & Garden-780L
models only)
SETTING THE CLOCK
1. Enter the program menu by holding down the
Light
button for 5 seconds. The display will
show the current clock setting with the hour
flashing.
2. Your system is set to a 24-hour time.
3. Setting the hour: Use the
Up/Down button
to adjust the hour. Press the Light button to
jump to the next parameter, the minutes.
4. Setting the minutes: Use the Up/Down button
to adjust the minutes. Press the Light button
to jump to the next parameter, the filter
cycles.
NOTE: If your spa loses power the clock will need
to be reset once power is regained.
FILTER CYCLES
Program the start time, duration and frequency of
your filter cycles. The default duration for the filter
cycles is 1 hour (2 times per day spread out by
12 hours) if the clock is not set and will start at
12. Filter cycles only run at low speed, however,
the second pump will purge for a minute first
during each filter cycle . The “Filter” indicator
lights up when a filter cycle is on. The duration of
each filter cycle can also be modified.
SETTING THE FILTER CYCLES
To program the filter cycle start time, duration
and frequency the following is required:
1. Press and hold Light button for 5 seconds
until clock hour is displayed (this time
should already be programmed, press
Light button two more times until FSxx is
displayed where xx represents the hour to
set the filter cycle.
2. Press the Up /Down button to adjust the
clock time for the first filter cycle to start (on
the hour only).
3. Press the Light button to store the cycle
start time and move to Fdxx the duration of
the filter cycle(s) where xx represents the
length of filter cycle time in hours
4. Press the Up /Down button to adjust the
duration (how long to run the filter cycle)
from 0 = no filtration to 24 = continuous
filtration. 0 is NOT recommended.
NOTE: The set duration will be the same time
length for each frequency.
5. Press the Light button to store the duration
and move to FFxx the frequency of the filter
cycle(s) where xx represents the amount of
times the filter cycle should come on.
6. Press the Up +/Down - button to adjust the
frequency (how many filter cycles within a
24 hour period). The amount of frequencies
allowed will depend on how long the duration
is set to since there are only 24 hours in a
day (example: if the duration is set to
13 hours or more than only 1 frequency can
be set, 9 - 12 hour duration only
2 frequencies can be set. In other words
the duration times the frequency must be 24
or less.
7. Wait 15 seconds to allow the exit timer to
expire and store the setting.