6
Safety switch
(Fig. 5)
●
Open the cover of the safety switch
●
Place the safety switch over the holes on the guide bar.
●
Close the cover and secure the switch in place with the two screws supplied as
shown in figure 5.
●
Use the two supplied cable clips to hold the cable in place.
Collecting bag
(Fig. 6)
●
Pull the safety flap upwards and hold.
●
Attach the holder of the collecting bag (1) to the hooks onto the housing (2) as shown
in figure 6 on previous page.
Setting the working depth
Caution! Never adjust the working height unless the motor is switched off and the
blade shaft has stopped moving.
•
The cutting height can be adjusted directly from the two front wheels.
•
5 different cutting height settings are available for each individual wheel.
•
Pull the level (1) as shown in figure 7 and move it forward, or backward to the desired
working depth for both wheels. Please note that the same position should be selected
for both wheels.
•
The available working depths for the rake and scarifier attachment can be seen below.
Rake
Scarifier
Position 1 (1st from rear)
10 mm
4 mm
Position 2
6.5 mm
0.5 mm
Position 3
3.0 mm
-3.0 mm
Position 4
-0.5mm
-6.5 mm
Position 5
-4.0 mm
-10 mm
Figure 7
