21
Instructions
5
Proper use
The 2 in 1 Petrol Grass Trimmer/Brush Cutter is to be used only for its prescribed
purpose. Any other use is deemed to be a case of misuse. The user/operator and
not the manufacturer will be liable for any damage or injuries of any kind caused
as a result of this.
Please note that our equipment has not been designed for use in commercial,
trade or industrial applications. Our warranty will be voided if the machine is
used in commercial, trade or industrial businesses or for equivalent purposes.
Operation
Please note that the statutory regulations governing noise abatement may
differ from one location to another.
Each time before use, check the following:
•
That there are no leaks in the fuel system.
•
That the equipment is in perfect condition and that the safety devices
and cutting devices are complete.
•
That all screws are securely fastened.
•
That all moving parts move smoothly.
Starting the engine when cold
Fill the tank with the oil/petrol mix. See also 'Fuel and oil'.
1
Set the equipment down on a hard, level surface.
2
Press the fuel pump (primer) (Fig. 1/Item 7) 10 times.
3
Move the On/Off switch (Fig. 1/Item 9) to 'I'.
4
Secure the throttle lever (Fig. 1 / Item 11). To do this, press the throttle lever
lock (Fig. 1/Item 12) and then press the throttle lever (Fig. 1/Item 11) and lock
the throttle lever by pressing the lock (Fig. 1/Item 10) at the same time.
5
Set the choke lever (Fig. 1/Item 5) to ' '.
6
Hold the equipment firmly and pull out the starter cable (Fig. 1/Item 4) until
you feel it begin to resist. Then tug sharply on the starter cable 4 times.
The equipment should start.
IMPORTANT!
Never allow the starter line to snap back. This may result in damage.
IMPORTANT!
Since the throttle lever is secured, the cutting tool starts to operate
immediately the engine is started.
GB
IRE
MODEL: GLBC 43
AFTER SALES SUPPORT
0151 649 1500
1890 946244
www.einhell.co.uk
