© 2018 Signify Holding. All rights reserved. This document contains information relating to the product portfolio of Signify which information may be subject to change. No representation or
warranty as to the accuracy or completeness of the information included herein is given and any liability for any action in reliance thereon is disclaimed. The information presented in this
document is not intended as any commercial offer and does not form part of any quotation or contract. All trademarks are owned by Signify Holding or their respective owners.
443561087360 A
Page 4 of 4
Signify Classified - Internal
INSTALLATION INSTRUCTIONS
121 WITH EMERGENCY BATTERY PACK OPTION
SPLICE BOX
(BY OTHERS)
5/16 MOUNTING
BOLT (1 OF 4)
BY OTHERS
SEALANT
SPLICES
(BY OTHERS)
MUST CONNECT SWITCH TO
CHARGE EMERGENCY
BATTERY PACK.
SEE INSTRUCTION NOTE #5.
1. APPLY A BEAD OF SELANT ON WALL AROUND
SPLICE BOX OPENING AND AROUND HOLES USED
FOR OPTIONAL MOUNTING BOLTS OR SCREWS
WHEN USING A 4" OCTAGONAL BOX (SHOWN), FILL
GAP BETWEEN WALL OPENING AND SPLICE BOX
WITH SEALANT.
APPLY SEALANT TO THE TOP INSIDE CORNERS OF
THE MOUNTING BRACKET.
2. PLACE MOUNTING BRACKET OVER SPLICE BOX AND
SECURE WITH J-BOX SCREWS.
3. LINE TO SUPPLY LINE, COMMON TO COMMON AND
GROUND TO GROUND.
4. PLACE SPLICES AND EXCESS WIRE IN SPLICE BOX.
CAREFULLY ENGAGE THE HANGER BRACKET TO THE
MOUNTING PLATE BEING CAREFUL NOT TO PINCH WIRES.
SLIDE DOWN FIXTURE TO REST AGAINST WALL.
TIGHTEN LOCKING SCREWS.
5. OPEN DOOR AND COMPLETE THE CONNECTION
AS SHOWN. THIS MUST BE CONNECTED SO THAT THE
EMERGENCY BATTERY PACK STAYS CHARGED.
6. CLOSE DOOR AFTER MAKING THIS CONNECTION.
LOCKING
SCREW
UNSWITCHED HOT 120 OR 277
EM DRIVER
AND BATTERY PACK
DRIVER
SWITCHED HOT 120 OR 277