GARDASOFT PP610, Руководство пользователя

Страница: 43 / 50

PP610/612 LED lighting controllers - User Manual
10.4 Pulsed mode output
These commands set the trigger source mode for pulsing, the pulse width
and delay.
Set the pulse parameters
RTfMmPpDd
Where:
f output channel (1 or 2)
m
= 1 to trigger on input 1
2 to trigger on input 2
3 to trigger on either input
p pulse width (in milliseconds)
d
delay before pulse (in milliseconds)
The RT command will not allow a delay to be set which is less than
the minimum for the current setting. When changing current and
delay values, it may be necessary to use the
RT command to set the
delay to a higher value, then use the RC command (see "Set the
output current" on the next page ) to set the current,and then use the
RT command again to set the delay to the required value.
The RT command can generate the following error codes:
Error
code
Description
44 Bad channel number
45 Channel number/trigger input mismatch
46 Invalid delay for programmed current
47 Invalid pulse width
— 43 —