TR-RC1xx - User Manual
2
Safety precautions
Read this before using the TR-RC. Always observe the following safety
precautions. If in doubt, contact Gardasoft Vision Ltd. The following
symbols are used in this guide:
Warning:
Read the instructions to understand the
possible hazards.
Warning:
Surface may get hot.
Where these symbols appear in this guide, refer to the text for the
precautions you should take.
2.1
Heat
Ensure the TR-RC is mounted correctly (see
), and that you do not exceed any of the ratings for the unit (see
11.1, Specifications and ratings
).
At its maximum ratings, the TR-RC’s enclosure (and heat sink in the case
of the TR-RC122) can exceed 65°C which is sufficient to cause a burn if
touched. Place in a position where personnel cannot accidentally touch it
and ensure there is a free flow of air around the unit.
2.2
Electrical
The TR-RC produces high energy pulses. Take care to connect the
outputs correctly and protect the output wiring and load from any short-
circuits. When switched off, energy remains stored in the TR-RC for about
15 seconds.
The TR-RC does not have complete tracking isolation of input and output.
Transients caused by inductive loads must be supressed externally to the
TR-RC.
Warning:
This is a Class A product. Its use in residential areas may cause
radio interference, and such use should be avoided unless special
measures are taken by the user to restrict emissions to a level that allows
the reception of broadcast transmissions.
2.3
General
The TR-RC must not be used in an application where its failure could be a
danger to personal health or damage to other equipment.
If the equipment is used in a manner not specified by the manufacturer,
the protection provided by the equipment may be impaired.
—
2
—
