STEP #5 STEP #6
STEP #5: FASTEN THE STIFFENER ENDS W/ THE SUPPLIED SCREW AS SHOWN IN 4 PLACES. THE TOP OF
THE STIFFENERS ARE TO BE FLUSH WITH THE RIBS AT EACH END.
STEP #6: PLACE THE TABLE TOP BACK EDGE IN LINE WITH FOLDING BRACKET ASSEMBLY AS SHOWN.
(THIS IS IMPORTANT SO THE TABLE TOP CAN BE “LIFTED” TO DOWN INTO THE FOLDED POSITION. )
STEP #7 THIS COMPLETES THE GT1301 ASSEMBLY.
STEP #7: WITH THE SUPPLIED 1” SCREWS, FASTEN THROUGH THE REAR 2 HOLES IN EACH BRACKET
ASSEMBLY INTO THE STIFFENER PREVIOUSLY INSTALLED ON THE TABLE TOP IN STEP #5..
PG 3 QUESTIONS ???? CALL 1-866 664 2724 REV 1, 8/11
