3
CONTROL4 DRIVER:
Control4 version required: 2.9.0 minimum
Initial release date: 01-01-2020
Last modified: 01-01-2020
Driver functions
This driver enables you to use the Gaposa LinkIT in a Control 4 installation. The driver consists
of a main gateway driver which communicates with LinkIT by RS232. Slave drivers then provide
control over 1 motor (blind) address. The driver can control up to 16 or 24 motors.
Important - Trying to control more motors than your LinkIT model can control will result in a
failure to operate.
Maximum number of linkITs
It is possible to install more than one LinkIT provided your Controller has the requisite number
of RS232 ports or a Remote RS232 - TCP/IP Convertor is used.
Driver installation
Download the driver from http://www.gaposa.it/eng/linkit/
Extract the drivers from the zip file to MyDocuments/Control4/Drivers folder on
your PC.
First Installation
If this is your first installation using the driver, please make sure you read the whole of this ma-
nual before touching any equipment.
We highly recommend setting up the driver in your office or shop first before installing it on site.
The RJ9 cable should be connected between the LinkIT and the Control4 controller before powe-
ring up. With the RS232 cable in place ensure LinkIT is powered from a 2 Amp 5Volt USB power
source.
Reference
Description
Serial connector with RJ9
Cabling distance
15 meters or more if special cables are used.
Cable options:
