USAGE
Common Precautions
(1) Be sure to use from step 1 as the pressure may be high when using the mat and cuffs.
(2) Please tighten connector to the inlet of main unit connector. If it is loosely fitted,
the air may not enter properly or work abnormally.
(3) Do not use on the bare skin.
(4) Please use without accessories.
(5) When using the cuff, zip up to the end and attach the velcro tape.
(6) Do not open the zipper while using the cuff (risk of injury).
(1) After connecting the power plug connected to the main unit to the outlet, and then please turn on the
power of the main unit.
(2) Fit the connector of the component you are using to the main connector inlet and push it fully to connect.
(3) Check if the display light of the component you want to use is lit in the display window of the main unit.
(4) Select a usage time (15 minutes / 30 minutes) - The default operating time is 15 minutes.
- Pressing the operating time button again, the usage time will be increased to 30 minutes
- The safety function automatically powers off after the operation time, so sleep during use is safe.
(5) Select use mode (Auto/ Manual/ S)
-
S mode :
Air inflates 5 air chambers in sequence repeatedly as programed without deflating air
completely before air inflate the next air chamber. This mode results in the most
powerful massage. Air release time can be adjusted by pressing “air vent time” button.
-
Manual mode :
Possible to select the only areas where you want to get a intensive massage.
-
Auto mode :
Air inflates 5 air chambers in sequence repeatedly as programed.
Air deflates completely before air inflate the next air chamber.
* CAUTION: We
strongly
recommead using arm cuff in Auto mode to avoid too much pressure in S mode.
BEFORE USING
ORDER OF USE
(COMMON)
USER’S GUIDE
10 11
(6) Select the operating pressure (pressure level 1 to 8, use the strong
▲
/ weak
▼
button)
- When using for the first time, be sure to use from step 1, and slowly increase the pressure to
suit your body.
- Air release time will be changed automatically according to steps 1 through 8 of the pressure levels.
If you feel that the pressure is weak, you may change the air release time so that you may feel a little
stronger pressure(but, it can be changed only in A mode).
- In case of air release time, you can feel a little more pressure when set to 6 seconds than
8 seconds and 4 seconds rather than 6 seconds.
(7) If you want to stop the operation, press the power button on the main unit or remote control.
(8) When you remove the connector from the main unit after use, the air used for each component
gradually falls out.
(9) How to use the remote control is the same as above.
