Gap Diagnostic IIDTool Pro, Руководство пользователя

Страница: 89 / 194

88 89
IIDT
ool
GAP Diagnostic 2019-07-15 All Rights Reserved
User Manual : Version 33, Firmware V3.0
The interpretation of each “status bit” is performed using the following table.
Interpretation of status bits
according to their state
Position
Status bit
Condition If status bit = 1 If status bit = 0
7
MIL Requested (warning
lamp)
A request was made to turn the
warning lamp ON.
No requests were made in
regards to warning lamps.
6
Test not completed in this
cycle Test or test sequence not comple-
ted for this fault during this cycle*
Test or test sequence com-
pleted for this fault during this
cycle*
5 Test failed since last clear
Test or test sequence for this fault
has failed at least once since the
last fault clear. Test or test sequence for this
fault has not failed since the
last fault clear.
4 Test not completed
The sequence of tests for this
fault has not been completed. The sequence of tests for this
fault was completed.
3 Confirmed
The fault presence is confirmed
at the time of reading.
The fault presence is not
confirmed at the time of rea -
ding.
2 Pending
The test(s) for this fault has failed
in current or previous cycle,
however, other tests will be
recorded.
There are no results pending.
1 Test failed this cycle*
The test(s) failed during this
cycle. Note that it is not confir -
med.
The test did not fail.
0 Test failed
Test(s) failed in this or previous
cycle(s).
Test(s) did not failed in this or
previous cycle(s).
Table 24. Interpretation of each “status bit”
*1 cycle = for example, starting and stopping the engine. Varies depending on the fault.
Note :
Be aware that a failed test is not necessarily a fault confirmation, because some faults are pro -
grammed to be confirmed if the test fails a number of times (eg. 5 tests). Then a fault is “intermittent”.
The 8 bits do not necessarily apply to all ECUs and faults due to their vocation. In these cases, Status
Bits “not applicable” will be set at any time to “1” and can bring confusion when interpreting faults. For
this reason, applying a filter is recommended. (
see
section 4.3.2
).