Ganz ZN-PT304L, Руководство пользователя

Страница: 12 / 73

-
11
-
Initial Access to the IP Camera
Check Network Settings
The IP Camera can be connected either before or immediately after software
installation onto the Local Area Network. The Administrator should complete the
network settings on the configuration page, including the correct subnet mask and IP
address of gateway and DNS. Ask your network administrator or Internet service
provider for the detail information. By default the IP Camera requires the Administrator
to run installation every time it reboots. If the network settings are to remain
unchanged, disable the Install option. Refer to “Network settings” on the System
Configuration page for details. If any setting is entered incorrectly and cannot proceed
to setting up the IP Camera, restore the factory settings following the steps in the
“Troubleshooting” chapter of the Appendix.
Add Password to Prevent Unauthorized Access
The default Administrator’s password is blank and the IP Camera initially will not ask for
any password. The Administrator should immediately implement a new password as a
matter of prudent security practice. Once the Administrator’s password is saved, the IP
Camera will ask for the user’s name and password before each access. The
Administrator can set up a maximum of twenty (20) user accounts. Each user can
access the IP Camera except to perform system configuration. Some critical functions
are exclusive for the Administrator, such as system configuration, user administration,
and software upgrades. The user name for the Administrator is permanently assigned
as “root”. Once the password is changed, the browser will display an authentication
window to ask for the new password. Once the password is set, there is no
provision to recover the Administrator’s password. The only option is to
restore to the original factory default settings.