PixelPro GXi Series
ZN-DNT352XE Series Installation Guide
03-2014-B
10
4.2. Adjusting the angle of the camera
Adjust the lens to the desired position by manually moving its upper lens shell, reinforced body
or horizontal platform in the following directions.
Caution
!
Refrain from continuously rotating the camera gimbal with excessive force to a
single direction as it is attached with the IR-LED cable inside the dome.
4.3. Adjusting zoom and focus
4.3.1. XE-xx models
1) Zoom and focus pullers are located inside the camera gimbal. Rotate the gimbal
counterclockwise and pull to detach. While detaching, do not pull straight off as there is an IR
sensor and LED power cable connected to a cover. To attach the cover back, rotate the gimbal
while gently pushing it in.
5) Unscrew the focus puller by turning it counterclockwise. Move it left or right and adjust the
image focus. After the setting, tighten the focus puller again by turning it clockwise.
Zoom puller
Focus puller
C. Tilt the lens by vertically
adjusting the camera.
A. To adjust lens position,
rotate the camera gimbal
B. To pan, rotate the lower
body of the camera gimbal
4) Unscrewing the zoom puller will
allow users to adjust the lens zoom
position. After the setting, tighten up
the zoom puller again by turning it
clockwise.
