PixelPro GXi Series
ZN1-D4NMZ43L Installation Guide
03-2014-B
14
②
Power Connection
The camera can be powered from either 12VDC or PoE. If the camera is powered via PoE, refer
to
Appendix (B). Power over Ethernet
for more details. To operate your camera using 12VDC,
make sure the polarity is correct before connecting the power cable. Incorrect connection may
cause damages to the device.
③
Analog Video Out Connection
Use a 75 ohm video coaxial cable to connect to a monitor’s analog video input and check the
camera’s connection and its image focus at the installation site. Be sure to press the output
configuration button (PAL/NTSC button) to see the video (Refer to
3. Part Names
to check the
location of the PAL/NTSC button). The factory default is ‘no video output’; Press once to set
the video to PAL, and press again to set the video to NTSC. Pressing the button again will go
back to ‘no video output’ mode, disabling the viewing through the analog video connection.
Note
i
Once the PAL/NTSC button is pressed, the video display lasts for 3 minutes
before it goes back to ‘no video output’ mode.
