Gantom 7 User Guide
Version 1.0 – 12/15/2017
ADDRESSING YOUR GANTOM DMX
The Gantom 7 can be given any DMX address from 1-506. To set your DMX address, first connect the
Gantom 7 to the DMX Programmer app by Gantom as was outlined earlier in this document. With the
Generic Console screen open, you should have full control of the fixture through the channel sliders. If
the light fixture is connected to the app but is not responding, try power cycling the light fixture.
Once you have verified that the light fixture is responding to control
signal from the app, tap the number field next to the word
“Address”. A new screen will pop up, prompting you to enter a DMX
address. After you enter your desired DMX address, the app will
return to the Generic Console screen. Finally, you must hit the
ASSIGN ADDRESS button in order to save the new address into the
fixture. Hitting the “Save” button will not save anything to the light
fixture’s memory.
SELECTING A DIFFERENT DMX CHANNEL MAPPING PROFILE
In order to select the preferred DMX channel mapping profile, you will need to follow the same
procedure for addressing the fixture, but instead of a fixture address you will enter one of the numbers
from the following table:
Channel Mapping Profiles
RGB RGBA RGBW (M)RGBAWU (M)RGBAWLU
Address to Enter:
507
508
509
510
511
Once you have entered the address corresponding to the desired profile, hit the “ASSIGN ADDRESS”
button. The light fixture should then cycle through a sequence of color flashes that matches the profile
you have selected. Please note that this will NOT actually change the DMX address of the fixture, since
the fixture can only be set to address 1-506.
