GL7p - Battery-powered, door-mounted electronic locker lock GL7p
Operation
www.gantner.com
HB_GL7p--EN_12
61
6.5.5
BATTERY Data Carrier
After the batteries are replaced in the GL7p, the lock must be set back to the normal operating mode using the
BATTERY data carrier. The internal action counter is reset to zero when the BATTERY data carrier is used. See
section
“4.2.3. Replacing the Battery” for more information.
After replacing the battery of a GL7p in personal locker mode, all settings stored in the lock remain as previously
configured.
6.5.6
SERVICE Data Carrier
The SERVICE data carrier is used to put the GL7p into configuration mode after the lock is connected to a computer
via USB (see section "4.3 USB Connection"). The settings of the GL7p are configured using GAT Config Manager
while the lock is in configuration mode (see "6. CONFIGURATION").
When the GL7p reads the SERVICE data carrier without being connected to a PC via USB cable, an antenna
calibration is performed, which locks the lock for a few seconds. After locking, the LED flashes red and the
SERVICE data carrier must be removed. The antenna is calibrated and the LED flashes green. Finally, a green LED
and a beep are emitted to indicate that the antenna calibration has been completed successfully. The locker is then
unlocked if it was locked before the calibration.
NOTE!
The SERVICE data carrier must be available for service employees who are required to configure the locker
system. Without the SERVICE data carrier, system configuration is not possible!
6.5.7
APP KEY Data Carrier
The APP KEY data carrier is required to configure the GL7p using the MoLA app. This app can be installed on mobile
devices with an Android operating system. When the lock is in factory mode and configured for the first time, the APP
KEY is not needed. For subsequent configuration changes however the APP KEY data carrier is required (see also
"5.3. Configuration with the MoLA App").
To configure the GL7p with GAT Config Manager, the APP KEY data carrier is not required.
6.5.8
BLOCKING Data Carrier (Optional Accessory)
This data carrier is used to block a locker which is locked by a user. After using the BLOCKING data carrier at the
locker, the user cannot open the locker anymore. To open the locker, a MASTER data carrier must be used. The
automatic open function will be disabled after the BLOCKING data carrier is used until the lock is opened with a
MASTER or OPEN MASTER data carrier.
The BLOCKING data carrier is not included in the scope of supply but can be ordered as an accessory.
