G&J Hall POWERBOR PB45, Оригинальное руководство пользователя

Страница: 7 / 28

7
PB45 - W18XC1053 - Revised 230712
SPECIAL SAFETY PRECAUTIONS - MAGNETIC DRILLS properly with the carrying
Safety Strap
The electro-magnet base on this power tool can release if there is a interruption in power
supply or electrical malfunction.
The safety strap provided should be used at all times to prevent the power tool from
falling in the event of power failure or electrical malfunction, possibly causing injury.
The safety ratchet strap should be attached to the fixing points provided and checked for
security before commencing any drilling operation.
Magnetic Adhesion
The magnets strength depends on the thickness and condition of the work piece material.
Always ensure that the work piece has a minimum thickness of 12mm or 1/2” to ensure
there is adequate magnetic adhesion.
If the work piece is less than 12mm or 1/2” then a piece of steel plate 12mm or 1/2” in
thickness and larger than the magnet footprint must be inserted to supplement the
magnetic adhesion.
The surface on which the magnet is placed should be clean, flat and clear from debris or
rust. The base of the magnet should be inspected to ensure it is also clean flat and clear
of debris.
Always check the magnet is securely adhered to the work piece before commencing any
drill operations.
Do not use other appliances on the same power receptacle, any variation in voltage
cause by other appliances could result in the magnet releasing. Always us the tool on its
own power receptacle.
This power tool can be used on a vertical surface or upside down provided there is
sufficient magnetic adhesion, extra care should be taken when drilling vertically or upside
down . When using the machine vertically or upside down it is possible hot and sharp
swarf or chips may fall. Always wear appropriate personal protective equipment
When Cutting
When using coolant of lubricants, ensure coolants and lubricants do not enter the drill
units ventilation/cooling openings.
If the drill is used in the upside down position, use cutting paste instead of cutting fluid to
prevent the possibility of fluids entering the electrical system.
When using annular cutters ensure that the slug ejected at the end of the cut will not
endanger anyone in the vicinity, if working at height some form of collection device for the
ejected slug may be necessary.
Care should be taken with the ejected slug, this will be both hot and sharp, gloves should
be worn when handling the slug.