STRONG. SIMPLE. COMPACT.
Custom Programming Function
Remote Charging
• Press the “DIY Key” (bottom left) for 2 seconds to enter into the Custom Programming Function.
• Select any color on the color wheel then press the “DIY Key” to save that color and enter the next color. You
can enter up to 10 colors in a single custom show.
• After the color selection, press the “Switch Key” (bottom center) to switch between jumping, smooth, or
flickering effects. Adjust the speed and brightness of the effect by the pressing the “SPEED” and “BRT”
buttons.
• Save the new program into the “Scene-mode Keys” (1 through 8) by pressing and holding a scene number
for 3 seconds.
• Connect the USB cable to the mobile charger or computer.
• The center indicator light flashes blue while charging and turns green when the charging is complete. The
remote can be charged in both the on and off state.
• During normal use the indicator light will flash red to indicate low battery.
Rev Date 21 0512
www.ggled.net
T
800.285.6780
E
COLOR CHANGING LED ARCH LIGHTING
WIRING DETAIL QUICK START GUIDE
Pre-Programmed Modes
Select between the 32 pre-programmed modes below
by pressing the “Changing Modes” buttom (bottom
center) and then the MODE + and “MODE – buttons.
The speed and brightness for each mode can also be
adjusted.
4. System Diagram:
3. Tables of Changing Mode:
Comment:
Speed/Brightness adjustable.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
No.
Mode
No.
Mode
Static red
Static green
Static blue
Static yellow
Static purple
Static cyan
Static white
RGB jumping
7 colors jumping
White strobe
7 colors strobe
Red fade out and fade in
Green fade out and fade in
Blue fade out and fade in
Yellow fade out and fade in
Purple fade out and fade in
Cyan fade out and fade in
White fade out and fade in
RGB fade out and fade in
Red/Green color smooth
Red/Blue color smooth
Green/Blue color smooth
Red/Yellow color smooth
Green/Cyan color smooth
Blue/Purple color smooth
Green/Yellow color smooth
Blue/Cyan color smooth
Red/Purple color smooth
Blue/White color smooth
RGB color smooth
Full-color smooth
Yellow/Purple/Cyan color smooth
Unlimited receivers can be installed within effective distance, no
wiring needed between the receivers, if you want to increase or
decrease the receivers, just activate or cancel the control ID will
be fine, no any changes and effects on other receivers.
LED RGB Programmable Controller
— 28 —
Single Color Operation
Select between vibrant static colors by using the
Full Spectrum Color Wheel or pressing Modes No.1
through No.7. For Static White press Mode No.7.
See the full table of pre-programmed modes on the
next page.
