G&F Manufacturing R-410A, Руководство по обслуживанию

Страница: 5 / 17

ATTENTION
:
You will find the Pool/Spa remote is no longer necessary; the board is programmed to
automatically recognize the switch and self-program.
2
nd
Option: Remote T- Stat (Disable)
This option is used for external controller systems with its own thermostat such as an
Aqua logic
!
or Aqua link
!
. Default is disabled. To enable, push Up or Down arrows
until display says “Enable.”
3
rd
Option: Pool Heat/Cool (Disable)
Once this is enabled a Heat/ Cool setting will come up on display. The board will
recognize when the temp of the pool has raise or dropped by 1˚ and will heat or cool
the pool until it reaches set point again.
(This option is only for Heat/Cool units.)
4
th
Option: Pool – Cool (Disable)
Once this option is enabled, it will give you a pool cool mode on display, use “Mode”
buttonto toggle (
This option is only for Heat/Cool units.)
5
th
Option: Solar Control (Disable)
This option allows your pool heater (with additional wiring) to monitor the pool solar
system’s performance and will automatically control the temperature.
6
th
Option: Time Delay (5)
Default is 5 minutes. You may temporarily set to 0 for service purposes, unit will reset
to 5 Mins after 10 Mins have passed.
7
th
Option: Spa Timer (Continuous)
This option is for rental properties or homeowners who do not want the spa left on
indefinitely. Options are “Continuous”, “Off”, or “Up to 20 hours” in 15-minute
increments.
CAUTION:
“Off” will not allow spa to run.
Page 5