G&D VisionXS-IP-F-DP-HR, Инструкция по установке и эксплуатации

Страница: 134 / 248

The VisionXS-IP-F-DP-HR series
5 · G&D VisionXS-IP-F-DP-HR
The VisionXS-IP-F-DP-HR series
KVM extenders of the VisionXS-IP-F-DP-HR series consist of a computer module and a
console module.
Connect the computer to be operated to the computer module ( VisionXS-IP-CPU ). The
remote console is connected to the console module ( VisionXS-IP-CON ).
Both the computer module and the console module are connected using two optical
fibres.
Signals of keyboard, mouse and DisplayPort™ video of the computer connected are
transmitted using these fibres and enable you to operate the computer remotely.
Use as extender or matrix switch modules
You can use the modules as either extender or matrix switch modules:

Extender modules: Configure a KVM-over-IP connection between the computer
and the console module. The configured connection between the modules is
restored each time the modules are restarted.

Matrix switch modules: In combination with the IP matrix switch ControlCenter-IP or
ControlCenter-IP-XS , you can use the modules as end devices of the matrix switch.
In this case, configure a KVM-over-IP connection to the IP matrix switch for the
modules.
In this configuration, the IP matrix switch enables the flexible connection of a con-
sole module to a computer module.
NOTE: You can also use a cable to establish a direct connection between computer
module and console module.
ADVICE: Use the IP-MUX functionality (see page 39 ff.) to make up to 20 computers
available in the OSD via separate computer modules.